Data Bus On Board Diagnostic Interface -J533-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the driver side knee airbag. Refer to KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .

-- Reach upward behind the pedal bracket to disconnect the connector -1-.

Fig 1: Connector Location

Courtesy of AUDI OF AMERICA, LLC

-- To disconnect the connector, press the tab, turn the retaining bracket and remove the connector.

-- Release the retainers in direction of -arrows- and remove the Data Bus On Board Diagnostic Interface -J533- -3- downward from the bracket -2-.

NOTE:

Check the exact connector assignment in the current wiring diagram. Refer to => Wiring Diagram.