Overview - Bumper Cover, Sedan From My 2017
WARNING: This page is about a different variant/trim than selected.
- Rear Reflector
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
- Rear Bumper Cover
- Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
- Cover
- Bolt
- 2 Nm
- Mount
- For the lane change assistance control module
- Lane Change Assistance Control Module
- Equipped on some models
- Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Figure.
- Nut
- Tightening sequence. Refer to Figure.
- Side Mount
- For the bumper cover.
- Removing and Installing. Refer to SIDE BUMPER COVER MOUNT, REMOVING AND INSTALLING, SEDAN .
- Upper Guide
- For securing the bumper cover
- Removing and Installing. Refer to UPPER GUIDE PIECE, REMOVING AND INSTALLING .
- Locking Mechanism
- For attaching the rear bumper cover to the upper mount
- Bolt
- Tightening sequence. Refer to Figure.
- Cover
- Quantity: 2
- Nut
- Quantity: 4
- 5 Nm
- Mount
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Nut
- Quantity: 2
- 2 Nm
- Cover
- For the towing eye
- Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
- Trim
- Only S line version
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION TRIM, REMOVING AND INSTALLING, S LINE FROM MY 2017 .