Wheel Housing Extension, Removing And Installing, RS3 From My 2019: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the adhesive surface using the Cleaning Solution :D 009 401 04 .
-- Remove the protective film from the adhesive tape -3 and 4-.
-- Position the wheel housing extension -1- and press in along the entire length.
- Vehicle resting time is at least 30 minutes at room temperature.