Overview - Impact Member, RS3
WARNING: This page is about a different variant/trim than selected.
- Bracket
- For Control Module for Adaptive Cruise Control -J428-
- Through MY 2018
- Bolt
- Tightening specification. Refer to OVERVIEW - ADAPTIVE CRUISE CONTROL .
- Impact Member
- Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to -item 6- OVERVIEW - HOOD - List Item:Screws
- Retaining Bracket
- For the hood release lever
- Bolt
- Tightening specification. Refer to -item 6- OVERVIEW - HOOD - List Item:Screws
- Quantity: 2
- Bolt
- 4.5 Nm
- Bracket
- For the signal horn
- Overview. Refer to OVERVIEW - HORN .
- Bolt
- Tightening specification. Refer to OVERVIEW - HORN .
- Bolt
- 50 Nm
- Quantity: 4
- Bracket
- For the Outside Air Temperature Sensor -G17-
- Removing and Installing. Refer to Outside Air Temperature Sensor -G17- BRACKET, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Quantity: 2
- Bracket
- For Control Module for Adaptive Cruise Control -J428-
- From MY 2019
- Adapter
- From MY 2019
- Bolt
- Tightening specification. Refer to OVERVIEW - ADAPTIVE CRUISE CONTROL .