Washer Fluid Reservoir Filler Tube, Removing And Installing, AUDI A3/S3 With Side Auxiliary Cooler: Removing
WARNING: This page is about a different variant/trim than selected.
-- If there is washer fluid in the filler neck, drain it by removing the right front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Place a drip tray under the windshield washer fluid reservoir.
-- Release the locking clamps -5 and 6- in direction of -arrows- and remove the water hose from the windshield washer pump.
-- Press the release button and remove the water hose -2- from the headlamp washer pump.
NOTE:
Ignore items -1, 3 and 4-.
-- Remove the bolt -1-.
-- Remove the filler neck -2- upward from the mount and the windshield washer fluid reservoir in direction of -arrow-.