Vibration Damper Seal, Replacing
Special tools and workshop equipment required
- Seal Installer - Crankshaft: T10354
- Press Piece - Gearbox: T10375
- Vibration Damper Assembly Tool - Knurled Nut: T10531/4 from the Vibration Damper Assembly Tool: T10531
- Seal Installer - Crankshaft: T40274
Procedure
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the seal -arrow- with the : T40274 .
-- Clean the contact and sealing surface.
-- Push the seal -arrow- on the : T10354 .
- The closed side of the seal points to the : T10354 .
-- Push the seal -arrow- with the : T10354 on the : T10531/2 and place on the lower timing chain cover.
-- Additionally attach the : T10375 and tighten the : T10531/4 .
-- Drive the seal in all the way using the : T10354 .
Installing
Install in reverse order of removal and note the following:
-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
Tightening Specifications