Bearing Bracket, Removing And Installing: Installing
-- Install the bolts -arrows- and tighten them. Tightening specification -item ) OVERVIEW - CYLINDER HEAD - List Item: Bolt.
-- Coat the holes -arrows- with engine oil.
-- Check if the adapter sleeve -1- is installed.
- Carefully connect the bearing bracket without tilting - risk of damage.
-- Attach the bearing mount and install the bolts -1 to 6- all the way by hand.
-- Remove the Tensioner Locking Tool: T40267 .
-- Tighten the bearing bracket bolts. Refer to Figure.
Installation is performed in reverse order of removal, noting the following:
-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .
After removing or replacing the chain drive components the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Electronics
- 01 - Engine electronics, functions
- 01 - Chain length diagnostic adaptation