Sub-Assembly Bracket, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• Replace the bolts that were tightened with an additional turn after removing them.
• Replace the O-ring and seals after removing.
• Used coolant cannot be used again.

-- Coat the new O-rings -4- with coolant.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

-- Insert the connection -2- into the coolant pump housing -3-.

-- Press the accessory assembly bracket -1- onto the connection, mount the bolts and tighten to tightening specification. Refer to Figure.

-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .