Balance Shaft Seal, Replacing, Intake Side
Special tools and workshop equipment required
- Seal Installer, Intermediate Shaft: T10356/1
Procedure
-- Remove the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .
-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
- Pay attention to the direction or rotation: the bolts for the drive wheel have left-hand threads - there is a risk of damaging the threads.
-- Remove the bolt -2- and then remove the drive wheel -1- for the coolant pump toothed belt.
-- Firmly press a screwdriver -1- on the surface of the sealing ring -2- in direction of -arrow B-.
-- Pry out the sealing ring in direction of -arrow A-.
-- Clean the contact and sealing surface.
-- Coat the sealing surface of the balance shaft -2- with transmission fluid.
-- Push the sealing ring -1- onto the balance shaft.
- The labeling "Inside" -arrow- must point to the engine.
- Pay attention to the direction or rotation: the bolts for the drive wheel have left-hand threads - there is a risk of damaging the threads.
-- Mount the : T10353/1 on the seal -1- and then tighten it carefully all the way into the cylinder block with the bolt -2-. Be careful not to tilt the seal when doing this.
-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .