General Information - Name Badges And Emblems, Replacing

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.

Special tools and workshop equipment required

Loosened name badges and emblems must be replaced.
The vehicle as well as the name badges and emblems must be at room temperature.
The adhesive surfaces must be free of dirt and grease.
If the Bonding Agent: D 355 205 A2 dries longer than 3 hours, then it must be primed again.

-- Completely remove any adhesive residue.

-- Clean the adhesive surfaces using Cleaning Solution: D 009 401 04 .

-- Apply Bonding Agent: D 355 205 A2 -item 1- to the adhesive surface -2- on the paint side using the Applicator: D 009 500 25 -3- and let it dry.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI OF AMERICA, LLC

-- Warm the adhesive areas to approximately 40 °C using a hot air blower.

-- After successfully assembling, press on the emblems again with the roller.