Molded Foam Part, Removing And Installing: Installing

Install in reverse order of removal and Note The Following: 

Vehicles through MY 2016: 

Courtesy of AUDI OF AMERICA, LLC

-- Position the pressure hose -2- at the center of the color mark -3- in the recess on the specified marking -4- in the molded foam part -1-.

-- Position the pressure hose evenly in both directions -arrows- in the recess in the molded foam part.

-- Fasten the molded foam piece -1- at the left and right with a cable tie -2- on the bracket, the cable tie head -arrow- must sit at the bottom the molded foam piece.

Courtesy of AUDI OF AMERICA, LLC