Dual Mass Flywheel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Shaft Seal Between Differential And Transmission Housing

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Always clean the clutch housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.

NOTE:

Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged. Refer to LEFT SEAL, REPLACING .

-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.

-- Clean the input shaft -arrow-.

Fig 2: Identifying Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines G 000 100.

-- Carefully mount the dual mass flywheel onto the input shaft -arrow- without tilting it.

Fig 3: Removing/Installing Flywheel Components

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .