Gear Oil Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Test requirement
- Gear oil temperature: 10 °C to 60 °C (50 °F to 140 °F)
- The rear final drive must be in its installed position.
- The vehicle must horizontal.
- Overview of the gear oil plugs, refer to Figure and Figure
Special tools and workshop equipment required
- Catch tray
Rear Final Drive 0BF
-- Remove the gear oil inspection plug -arrow- located on the right side of the final drive.
Rear Final Drive 0BE
-- Remove the gear oil inspection plug -1-.
Continuation for All Rear Final Drives
- The fluid level is correct when the rear final drive is filled up the lower edge of the fluid fill hole.
-- Fill the gear oil if necessary.
-- Install and tighten the gear oil inspection plug -arrow-. Tightening specifications -item 22- REAR FINAL DRIVE OVERVIEW => List Item:Gear Oil Inspection Plug