ATF Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Test requirement
- ATF temperature: 10 °C to 60 °C (50 °F to 140 °F)
- The rear final drive must be in its installed position.
- The vehicle must horizontal.
Special tools and workshop equipment required
- Catch tray
-- Remove the ATF inspection plug -1-.
CAUTION:
- The ATF check plug -1- is located on the left side of the rear final drive. >>ATF<< on the final drive housing -arrow-.
- Overview of the ATF plugs, refer to Figure.
- The ATF level is correct when the rear final drive is filled up to the lower edge of the fluid fill hole.
If the ATF level is correct:
-- Install and tighten the new ATF inspection plug. Tightening specification -item 12- REAR FINAL DRIVE OVERVIEW => List Item:ATF Check Plug.
If the ATF level is not correct:
-- Fill with ATF. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .