Cylinder Bank 1 (Right):

-- Attach both of the camshaft adjusters without camshaft timing chains to the cylinder head and then loosely screw on the bolts -1 and 2-.

-- Position the :T40269  onto the camshaft adjuster for the right exhaust camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the exhaust camshaft with the wrench clockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the left bolt -left arrow- on the :T40264/1  .

-- Position the :T40269  onto the camshaft adjuster for the right intake camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the intake camshaft with the wrench clockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the right bolt -right arrow- on the :T40264/1  .

-- Counterhold with the wrench while removing the bolts -1 and 2- and then remove the camshaft adjuster.