LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S7 Premium Plus >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger System (Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC) >> Turbocharger, Supercharger >> Turbocharger >> Engine Cover Temperature Sensor -G765-, REMOVING AND INSTALLING >> Removing

Engine Cover Temperature Sensor -G765-, REMOVING AND INSTALLING: Removing

NOTE:

Follow all the rules of cleanliness. Refer to CLEAN WORKING CONDITIONS .

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.

-- Remove the air duct hoses by loosening the hose clamps -2-.

GWWA24-11121Courtesy of AUDI OF AMERICA, LLC

-- Release the retainer -3- turn the air filter housing upper section -1- counter-clockwise in direction of -arrow B- and then remove it.

NOTE:

Ignore -arrow A-

-- Disconnect the connector -1-.

GWWA24-11080Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then remove the Engine Cover Temperature Sensor -G765-.

scientia non olet · About LEMON Manuals