Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Tighten the bolts -1 through 6- on the mounting strap and the support plate.
-- Tighten the fuel filler tube bolts -1 and 2-.
-- Install the right locking flange cover. Refer to .
-- Install the rear bench seat. Refer to OVERVIEW - SEAT BENCH/SINGLE SEAT .
-- Connect the batter while doing so follow all steps after connecting the battery. Refer to BATTERY .