Output Shaft: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Thrust Plate VW 401
Thrust Plate VW 402
Punch VW 407
Thrust Disc VW 412
Tube 60 mm Dia. VW 415 A
Sleeve VW 519
Slide Hammer-Complete Set VW 771
Driving Sleeve 32 - 109
Sleeve 40 - 21
Seal Driver 3013
Tube 3296
-1- Internal Puller Kukko 21/1
-3- Separating Tool Kukko 17/2
Inductive Heater VAS 6414

NOTE:

Removing and installing 1st, 2nd and reverse gears. Refer to SHIFT FORK GROUP, INPUT SHAFT, 1ST, 2ND AND REVERSE GEAR OUTPUT SHAFTS .

Remove the 3rd and 4th gear wheels and the roller bearings from the output shaft.

-- Remove the 4th gear wheel locking ring.