Installation [10/2013 - ]

WARNING: This page is about a different car, the 2014 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.

INSTALL ROCKER PANEL MOLDING ASSEMBLY
1. Install 10 new clips to the rocker panel molding assembly.
2. Engage the 10 clips.
3. Install the screw.
4. Install the 8 clips.
5. Install the bolt.
6. Install a new grommet.
7. Install the rocker panel molding assembly with the 2 screws.
INSTALL NO. 2 ROCKER PANEL MOLDING PROTECTOR See step 1