Installing The Over-Center Spring

WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clipping Bearing Shell

Courtesy of AUDI OF AMERICA, LLC

-- Clip the bearing shell -1- in the appropriate bearing position.

Bearing Position	Vehicles With
"I" -arrow A- :	All engine types excluding 1.8 L TFSI-engines (PR number TF6, TW2, TH2)
"II" -arrow B-	1.8 L TFSI engine (PR Number TF6, TW2, TH2)

-- Install the over-center spring -2-.

The black side -arrow C- faces the clutch pedal.

-- Press the clutch pedal -1- down as far as the stop and insert the over-center spring -2- with the T40025.

Fig 2: Actuating Clutch Pedal

Courtesy of AUDI OF AMERICA, LLC

-- Pull the clutch pedal back to its rest position. Remove the assembly clamp while the over-center spring is stretched.

-- Install the footwell vent. Refer to OVERVIEW - A/C SYSTEM .

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Install the instrument panel cover on the driver side. Refer to INTERIOR EQUIPMENT (CABRIOLET) .