Right Flange Shaft, Removing And Installing: Installing

Fig 1: Identifying Right Flange Shaft And Circlip

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Replace the circlip on the right flange shaft.

-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.

-- Fill the space between the sealing- and dust lip half way with sealing grease.

-- Drive in the right flange shaft using the Bearing/Bushing Installer - Multiple Use VW295.

-- Check the transmission oil lever in the final drive and fill if necessary. Refer to TRANSMISSION FLUID LEVEL, CHECKING .