Tail Pipes, Aligning

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

Version with A Tail Pipe

Fig 1: Checking Distance Of End Pipes At Left/Right To Bumper

Courtesy of AUDI OF AMERICA, LLC

-- Check the distance of left and right tail pipes to the bumper:

Dimension -x- left = dimension -x- right.

Version with Dual Tail Pipes

Fig 2: Checking Distance Between Tailpipe And Bumper

Courtesy of AUDI OF AMERICA, LLC

-- Check distance of left and right tail pipes to bumper:

Dimension -x- left = dimension -x- right.

Continuation for All

Fig 3: Identifying Brace Threaded Connection -Arrow-

Courtesy of AUDI OF AMERICA, LLC

Correct dimension "x" as follows if necessary:

-- Loosen the brace threaded connection -arrow- between the exhaust pipes.

-- Adjust the distance of the rear mufflers to each other.

Tightening specification: Refer to OVERVIEW - MUFFLER .