Cam Actuator, Removing And Installing
Cylinder Bank 1 (Right) Cam Actuator, Removing
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
All additional procedures are described. Refer to CAM ACTUATOR, REMOVING AND INSTALLING .
Cylinder Bank 2 (Left) Cam Actuator, Removing
-- Remove the Engine Control Module -J623- from the bracket and move to the side. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .
-- Free up the coolant line -3- and wiring harness -2-.
-- Remove the bolts -arrows- and remove the engine control module bracket -1-.
All additional procedures are described. Refer to CAM ACTUATOR, REMOVING AND INSTALLING .
Installing
Additional procedures:
-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
Tightening Specifications
- Refer to OVERVIEW - ENGINE CONTROL MODULE