Overview - Timing Chain Cover: Notes
- O-ring
- Always replace after removing.
- Lubricate with engine oil
- Oil Dipstick Tube
- Bolt
- 9 Nm
- Left Coolant Pipe
- Removing and installing. Refer to COOLANT PIPES, REMOVING AND INSTALLING [CVKB, DBPA, CWNA, CVLA, DEMA, DHDA] .
- Bolt
- Tightening specifications and sequence. Refer to Figure.
- Bolt
- 9 Nm
- Camshaft Adjustment Valve 1 -N205-
- Removing and installing. Refer to CAMSHAFT ADJUSTMENT VALVE 1 -N205- / EXHAUST CAMSHAFT ADJUSTMENT VALVE 1 -N318-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Exhaust Camshaft Adjustment Valve 1 -N318-
- Removing and installing. Refer to CAMSHAFT ADJUSTMENT VALVE 1 -N205- / EXHAUST CAMSHAFT ADJUSTMENT VALVE 1 -N318-, REMOVING AND INSTALLING .
- Seals
- Always replace after removing.
- Installation position: Smaller inner diameter outward
- Remove to replace the upper timing chain cover -item ) OVERVIEW - TIMING CHAIN COVER - UPPER TIMING CHAIN COVER
- Lubricate with engine oil
- Seal
- Replace if damaged or leaking
- Cap
- Upper Timing Chain Cover
- Removing and installing. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Seal
- Replace if damaged
- O-rings
- Always replace after removing.
- Coat with engine oil
- Alignment Pin
- Quantity: 2
- For the lower timing chain cover
- Bolt
- Always replace after removing.
- Tightening specifications and sequence. Refer to Figure.
- Lower Timing Chain Cover
- With gasket
- Always replace after removing.
- Removing and installing. Refer to LOWER TIMING CHAIN COVER, REPLACING .
- Seal
- For the vibration damper
- Replacing. Refer to VIBRATION DAMPER SEAL, REPLACING .
- Plugs
- Always replace after removing.