Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while Noting The Following:

-- Push the Drive Position Sensor -G676- on the parking lock gear and at the same time pay attention to the different recesses -arrows- and secure with the bolt -1- hand-tight.

GWWA34-11689

Courtesy of AUDI OF AMERICA, LLC

-- Check, if the splines of the Drive Position Sensor -G676- are flush with the splines of the parking lock gear.

GWWA34-11688

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -arrow- to the tightening specification.

GWWA34-11616

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Pay attention when installing the Parking Lock Solenoid -N486- that the alignment pin is seated correctly.

GWWA34-11617

Courtesy of AUDI OF AMERICA, LLC

-- Install both bolts in direction of -arrows- with lightened spring force and tighten to the tightening specification.

GWWA34-11551

Courtesy of AUDI OF AMERICA, LLC

-- To do this using a pin punch shaft turn the parking lock approximately 3° against the spring force.

NOTE:

Pay attention to the correct installation position!

The lever from the parking lock is flush to the shaft splines -arrow-.

GWWA34-11630

Courtesy of AUDI OF AMERICA, LLC

If necessary align with less spring force!

NOTE:

If necessary the spring pin can also be pushed in using pliers.

Never drive in the tensioning pin because the shaft will be damaged.

-- Press on the tensioning pin using the :3276/1 .

GWWA34-11553

Courtesy of AUDI OF AMERICA, LLC