Input Shaft Seal, Replacing: Overview
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Puller - Crankshaft/Power Steering Seal :T20143
- Thrust Piece :T40300
- Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
-- With the :T20143 carefully remove the seal -arrow- from the housing.
-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.
NOTE:
Pay attention to the installed position.
-- Drive in the new seal to the stop using the :T40300 .
-- Install the clutch. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .