Flywheel, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
There is a normal >>clicking<< in the dual mass flywheel with "LuK" centrifugal pendulum absorber -A-.
A >>clicking<< is heard when turning the clutch module -A- approximately every 90°. This noise comes from shifting pendulum masses (centrifugal pendulum absorber) in the dual mass flywheel and is not a fault.
- Secure the transmission on the :VAS6095 . Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Attach the :T40176 to the flywheel -A- with the nut -B- -arrow-.
-- Turn the :T40176 upward.
NOTE:
To prevent the flywheel from tilting, counterhold it underneath as shown.
-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.