Parking Brake, Manually Loosening: Procedure
CAUTION:
- Before removing the parking brake motor, secure the vehicle from rolling.
-- Release The Parking Brake.
-- Switch off the ignition.
-- Remove the rear wheel. Refer to WHEEL, CHANGING AND MOUNTING / WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Disconnect the connector -3- for the parking brake motor.
-- Open the clip -2- and free up the brake pad wear indicator wire.
-- Remove the bolts -arrows-.
-- Remove the parking brake motor -1- from the brake caliper.
-- Remove the seal.
-- Using a TX45 socket -arrow-, turn the drive axle back until the brake is loosened.
-- After eliminating the fault, install the parking brake motor. Refer to LEFT AND RIGHT PARKING BRAKE MOTOR -V282- / -V283-, REMOVING AND INSTALLING .