Overview - Transverse Link
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2017 Audi A3, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Transverse Link For A Vehicle With FWD Is Shown In The Illustration.
- Eccentric Bolt
- Perform a vehicle alignment after loosening. Refer to VEHICLE ALIGNMENT .
- Do not turn more than 90° right or left (that is smallest to largest possible adjustment)
- Subframe
- Eccentric Washer
- Inner bore with tab
- Nut
- 95 Nm without Insert Tool - 18mm :T10179
- 80 Nm with Insert Tool - 18mm :T10179
- Always replace if removed
- Always tighten threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Eccentric Bolt
- Perform a vehicle alignment after loosening. Refer to VEHICLE ALIGNMENT .
- Do not turn more than 90° right or left (that is smallest to largest possible adjustment)
- Eccentric Washer
- Inner bore with tab
- Nut
- 95 Nm
- Always replace if removed
- Always tighten threaded connections in curb weight position (95 Nm). Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Upper Transverse Link
- Removing and installing. Refer to UPPER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Nut
- Always replace if removed
- Washer
- Washer
- For AWD vehicles only
- Bolt
- 130 Nm + 180° turn
- Always replace if removed
- Always tighten threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Wheel Bearing Housing
- Different versions. For the correct allocation. Refer to the parts information
- Expanding Rivet
- Quantity: 2
- Nut
- Always replace if removed
- Bolt
- 70 Nm + 180° turn
- Always replace if removed
- Always tighten threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Lower Transverse Link
- Removing and installing. Refer to LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Internally Threaded Pop Rivets
- Stone Chip Protection
- Different versions. For the correct allocation. Refer to the parts information.
- Bolts
- 8 Nm