Transmission Fluid Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Drain the transmission fluid (refer to TRANSMISSION FLUID, DRAINING AND FILLING ) and leave the : SMN372500 underneath.
-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER .
-- Remove the bolts -arrows- and remove the transmission fluid pump cover -A-. While doing so, allow the transmission fluid still in the cover to drain into the : SMN372500 .
-- Remove the bolts by using the : T10054 for the upper bolt -arrow-.
-- Remove the transmission fluid pump from the alignment pins and the input shaft.