Bevel Box, Tightening Specification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Replace the bolts after removing them.

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specification/Additional Turn
1.	-arrows-	Install all the way by hand
2.	-arrows-	40 Nm diagonally
3.	-arrows-	90° additional turn, diagonally

Fig 1: Tightening Sequence for Bevel Box Bracket (Vehicles with TFSI Engine)

Courtesy of AUDI OF AMERICA, LLC

Step	Bolts	Tightening Specification
1.	-1-	Install all the way by hand
2.	-2-	40 Nm
3.	-1-	40 Nm

Fig 2: Tightening Sequence for Bevel Box Bracket (0CN Transmission Support)

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specification
1.	-1-	Install all the way by hand
2.	-2-	40 Nm
3.	-1-	40 Nm