LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (CONTROLS, HOUSING [0D9] (1 Of 2) -- (A3 SEDAN)) >> 34 Controls, Housing >> Bevel Box >> Bevel Box, Installing >> Procedure

Bevel Box, Installing: Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Place the bevel box with the right flange shaft on the transmission while turning the flange shaft at the same time.

-- Tighten the bevel box on the transmission.

-- Install the fan shroud. Refer to RADIATOR/RADIATOR FAN [For engine(s) CNSB, CNTC] or RADIATOR/COOLANT FAN [For engine(s) CRUA, DEJA] .

-- Gear Oil, Checking Level. Refer to GEAR OIL, CHECKING LEVEL .

scientia non olet · About LEMON Manuals