Overview - Camshaft Timing Chain, Engine With One Camshaft Adjuster: Notes

Fig 1: Exploded View Of Camshaft Timing Chain (Engine With One Camshaft Adjuster)

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • 4 Nm + 90° 
   • Always replace after removing
2. Chain Tensioner
   • Is under tension
   • Secure using the Locking Tool:T40267  before removing
3. Timing Chain Tensioning Rail
4. Guide Pin
   • 20 Nm 
5. Bolt
   • Tightening Specifications and Sequence. Refer to Fig 4.
   • Aluminum bolt: Always replace after removal
6. Adapter Sleeve
   • Depending on the version, not present on every bearing bracket
7. Control Valve
   • 35 Nm 
   • Left-hand thread
   • Different versions depending on the version.
   • Checking using the Vehicle Diagnostic Tester Fig 2.
8. Bolt
   • Tightening Specifications and Sequence. Refer to Fig 4.
   • Always replace after removing
9. Washer
10. Bearing Bracket
    • Assembly instructions. Refer to Fig 3.
    • Removing and installing. Refer to BEARING BRACKET, REMOVING AND INSTALLING, ENGINE WITH ONE CAMSHAFT ADJUSTER .
11. Camshaft Timing Chain Guide Rail
12. Camshaft Housing
13. Camshaft Timing Chain
    • Before removing, mark the running direction with paint
    • After procedures on the chain drive perform the adaptation using the Vehicle Diagnostic Tester
    • Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING, ENGINE WITH ONE CAMSHAFT ADJUSTER .
14. Camshaft Timing Chain Guide Rail
15. Guide Pin
    • 20 Nm 
16. Three Stage Chain Sprocket
    • Crankshaft
    • Installation position. Refer to Figure.

Fig 2: Identifying Control Valve

Courtesy of AUDI OF AMERICA, LLC

Fig 3: Exploded View Of Bearing Bracket With Bolts - Assembly Instructions (Steel Bolts vs Aluminum Bolts)

Courtesy of AUDI OF AMERICA, LLC

If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.

If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Refer to the parts information for the correct bolt.

Fig 4: Bearing Bracket Bolts - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten The Bolts In The Steps Shown In The Sequence: