CONTROL VALVE FOR Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the O-ring after removal.

-- Install the noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Install the upper toothed belt guard. Refer to UPPER TOOTHED BELT GUARD, REMOVING AND INSTALLING .

-- After replacing or removing and installing the camshaft adjuster, perform the necessary adaptations using the Vehicle Diagnostic Tester and refer to PERFORM ADAPTATIONS AFTER COMPONENT REPLACEMENT .