Component Location Overview - Transmission Control
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Lamp Switch -F- /Brake Pedal Switch -F63-
- On the brake master cylinder
- Component location overview. Refer to COMPONENT LOCATION OVERVIEW - ABS/ESP .
- Dual-Clutch Transmission Mechatronic -J743-
- Bolted to the front of the transmission housing.
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Selector Lever -E313-
- With Selector Lever Sensor System Control Module -J587-, Shift Lock Solenoid -N110- and Selector Lever Park Position Lock Switch -F319-
- The components are integrated in the selector mechanism circuit board and cannot be replaced separately.
- Selector mechanism, removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
- Selector Lever Transmission Range Position Display Unit -Y26-
- Removing and installing. Refer to SELECTOR LEVER TRANSMISSION RANGE POSITION DISPLAY UNIT -Y26-, REMOVING AND INSTALLING .
- Kick Down Switch
- A programmed value for the Accelerator Pedal Position Sensor -G79- /Accelerator Pedal Position Sensor 2 -G185- (integrated in accelerator pedal module) is saved in the engine control module as a kick-down signal.
- Signal transmitted from engine control module to transmission control module via the CAN bus.
- Accelerator pedal module. Refer to OVERVIEW - ACCELERATOR PEDAL MODULE .
- Data Link Connector
- For the Vehicle Diagnostic Tester
- In driver footwell
- Check all of the listed components using the Vehicle Diagnostic Tester in Guided Fault Finding .