Right Seal, Replacing, Fwd Vehicles

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller - Crankshaft/Power Steering Seal: T20143
Puller - Crankshaft/Power Steering Seal: T20143/2
Seal Installer - Flange Shaft: 3377
Sealing Grease Refer to the Parts Information.

Procedure

The transmission is installed.

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the seal using the : T20143/2

-- Coat the outer edge and sealing lips on the new seal with transmission fluid.

Fig 1: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct Sealing Grease.

-- Install the seal all the way in using the : 3377 . Be careful not to tilt it.

Fig 2: Driving New Seal In As Far As Stop

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .