Seal On Bevel Box Between Transmission And Bevel Box, Replacing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Bevel Box: T10298
Puller - Crankshaft/Power Steering Seal: T20143
Sealing Grease. Refer to the Parts Information.

Procedure

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .

-- Pry out the seal on the bevel box using the : T20143/1 or : T20143/2 .

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.

Fig 2: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct sealing grease.

-- Drive the new seal all the way in using the : T10298 . Do not tilt it while doing so.

Fig 3: Driving In Sealing Ring As Far As Stop Using Thrust Piece T10298

Courtesy of AUDI OF AMERICA, LLC

-- Install the bevel box. Refer to BEVEL BOX, REMOVING .