Bearing Bracket, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the bolts -arrows- and tighten them. Tightening specification -item ) OVERVIEW - CYLINDER HEAD - Bolt.
-- Coat the holes -arrows- with engine oil.
-- Check if the adapter sleeve -1- is installed.
- Carefully connect the bearing bracket without tilting - risk of damage.
-- Attach the bearing mount and install the bolts -1 to 6- all the way by hand.
-- Remove the :T40267 .
-- Tighten the bearing bracket bolts. Refer to BEARING BRACKET - TIGHTENING SPECIFICATIONS AND SEQUENCE .
Installation is performed in reverse order of removal, noting the following:
-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- After working on the chain drive adapt the chain length. Refer to Vehicle Diagnostic Tester.