Steering Gear, Servicing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Right Tie Rod End
- Check dust caps for damage and correct seating.
- Nut
- 70 Nm
- Counterhold the nut on tie rod end using a wrench when loosening and tightening
- Spring Clamp
- Boot
- Removing and installing. Refer to BOOT, REMOVING AND INSTALLING .
- Check for damage
- Must not be twisted after toe is adjusted
- Clamp
- Always replace if removed
- Install new clamp using Locking Pliers :VAS6199
- Tie Rod
- 100 Nm
- If faulty, replace with tie rod end
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .
- Steering Gear Housing
- Left Tie Rod End
- Check dust caps for damage and correct seating
- Nut
- 70 Nm
- Counterhold the nut on tie rod end using a wrench when loosening and tightening
- Spring Clamp
- Boot
- Removing and installing. Refer to BOOT, REMOVING AND INSTALLING .
- Check for damage
- Must not be twisted after toe is adjusted
- Clamp
- Always replace if removed
- Install new clamp using Locking Pliers :VAS6199
- Tie Rod
- 100 Nm
- If faulty, replace with tie rod end
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .