Wheel Bearing Unit, Removing And Installing, Multi-Link Suspension Vehicles With Front Wheel Drive: Installing
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Installation Is Reverse Of Removal, Noting The Following:
-- Carefully slide wheel hub/wheel bearing unit onto the axle stub.
Make sure that wheel hubs/wheel bearing unit does not tilt!
-- Tighten using a new multi-point socket head bolt -1-.
CAUTION:
Never use an impact wrench when tightening the bolt -1- using the :T10162A .
NOTE:
First tighten the bolt to the given tightening specification using the torque wrench.
Use a rigid wrench to apply additional torque angle.
-- Install the new dust cap with the :3241/4 -1-
NOTE:
Always replace dust caps.
Damaged dust caps allow moisture to enter. Therefore, always use the tool shown.