LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Rear Suspension -- (A3 Cabriolet / Sedan)) >> 42 Rear Suspension >> Wheel Bearing And Trailing Arm >> Wheel Bearing Housing Bonded Rubber Bushing, Replacing >> Removing >> Installing Bonded Rubber Bushing

Installing Bonded Rubber Bushing

WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
GWWA42-10685Courtesy of AUDI OF AMERICA, LLC
  1. :3346/2 
  2. :3346/3 
  3. Thrust Piece from the :3301 
  4. :3378 
  5. Bonded Rubber Bushing
  6. Wheel Bearing Housing
  7. :3346 
  8. :3346/3 

-- Install the bonded rubber bushing by turning the :3346/3  -2 -. If necessary, counterhold on the :3346/2  -1-.

NOTE:

Do not use lubricant!

Insert bearing with care so it is not canted.

-- Check the installed position after installing the bonded rubber bushing.

-- Install the bonded rubber bushing again if dimensions -A and B- are different.

scientia non olet · About LEMON Manuals