LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Rear Suspension -- (A3 Cabriolet / Sedan)) >> 42 Rear Suspension >> Drive Axle >> Outer CV Joint, Checking >> Installing

Outer CV Joint, Checking: Installing

WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Installation Is Reverse Of Removal,Noting The Following: 

-- Press quantity of grease specified in table. Refer to DRIVE AXLE WITH 90 MM DIAMETER OUTER CV JOINT  into joint body.

-- Insert cage with hub into joint body.

NOTE:

Cage must be installed laterally correct.

-- Press in opposing balls in sequence, during this, previous position of ball hub to ball cage and to joint body must be established again.

-- Install new circlip in shaft.

-- Distribute remaining grease in the joint boot.

scientia non olet · About LEMON Manuals