Upper Transverse Link, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Installation Is Reverse Of Removal, Noting The Following:

Transverse link connection may only be carried out of dimension between wheel hub center and lower edge of wheel housing, measured before assembly, is achieved. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
Note the applied marking of the eccentric bolt -3- to the subframe.

-- An axle alignment may be required. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .