Turbocharger, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal and Note The Following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Replace seals, gaskets, O-rings and self-locking nuts after disassembly.
- Coat the turbocharger stud bolts with hot bolt past. Refer to the Parts Catalog.
- Fill the turbocharger with engine oil at the oil supply line connection.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Catalog.
- After installing the turbocharger, let the engine idle for approximately one minute without increasing the engine speed. This ensures adequate oil supply to the turbocharger.
- Used coolant cannot be used again.
-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .
-- Install the Heated Oxygen Sensor -G39-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
-- Install the air filter housing. Refer to Air FilterAir Filter .
-- Check the oil level. Refer to ENGINE OIL .
-- Fill with coolant. Refer to Cooling SystemCooling System .