Vehicles With Multi-Link Suspension - Rear Axle Camber: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the nut -A- on the upper control arm threaded connection from the subframe and loosely install a new nut.
-- Set the camber by turning the eccentric bolt -B-.
- Use the 18 mm socket -1- from the :T10001
To turn the eccentric bolt, turn the hex head at the "top of the bolt".
NOTE:
The maximum adjustment range is 90° to left or right of center position.
-- Tighten the nut -A- using the :T10179 .
-- Use the :T10179 -1- as shown.
-- After the nut is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .