Transmission, Removing [CNSA, CNTC, CYFB, CNSB]: Notes
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Support Bridge :10-222A with the Engine Support - Bracket with Spindle and Hook :10-222A/31
- Engine Sling - Engine Bracket :2024A/1
- Transmission Support :3282
- Transmission Support - Pins 29 :3282/34
- Transmission Support - Mounting Plate 42A :3282/42A
- Engine/Gearbox Jack :VAG1383A
- Hose Clamps - Up To 25mm :3094
- Engine Bung Set :VAS6122
- :T40093/3-5 from the Engine Support Supplement Kit :T40093A
- :T40150/4 from the Engine Support Bracket :T40150
- Engine Support Bridge - Engine Support 4 :10-222A/4
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe
- Bolts - Transmission
- Bolts - Drive Axle
- Bolts - Transmission Bracket
- Bolts - Driveshaft
- Bolts - Bevel Box
Tool Development
-- If the adapter for :10-222A/4 does not have the indicated holes -arrow- shown they must be added.
- Dimension -a- = 225mm.
- Hole diameter = 12.5 mm