Transmission Fluid Level, Checking: Notes
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Adapter For Oil Filling
- Used Oil Collection and Extraction Unit :SMN372500
- Brake Line Tool Kit - Pipe Cutter :VAS6056/2
- Original transmission fluid for the S tronic transmission 0D9. For the part number.
- Protective eyewear
- Acid-resistant safety gloves
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Seal - Drain and Check Plug
Measure the Length of the Bleed Pipe on the Adapter For Oil Filling. Shorten it if Necessary.
Shorten the pipe to dimension -a-. This assures the pipe on the Adapter For Oil Filling will not touch the bottom on some oil containers.
- -a- = 210 mm
NOTE:
Dimension -a- is measured starting from the shaft (the green surface) on the Adapter For Oil Filling.
-- Make a mark on the bleed pipe, dimension a, and cut it, with the pipe cutter :VAS6056/2 .