Transmission Fluid Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Replace the transmission fluid pump cover and bolts.

Replace the gasket -B- and cover for the transmission fluid pump.

-- Check whether alignment pins -C- are inserted in transmission housing.

-- Slide transmission oil pump input shaft -A- into transmission as far as stop by turning shaft slightly.

If transmission oil pump input shaft -A- is inserted correctly, dimension -a- = approximately 23 mm.

Courtesy of AUDI OF AMERICA, LLC

-- If there are metal shavings on sensor wheel -B-, remove shavings, but sensor wheel must not be demagnetized.

-- Remove paper seal between transmission oil pump and transmission.

-- Remove rest of paper seal and clean inside of transmission.

-- Clean sealing surfaces; they must be free from oil or grease.

-- Insert new paper seal between transmission oil pump and transmission, secure with gear oil if necessary.

-- Place transmission oil pump on input shaft and tighten. Refer to the appropriate service information. .

Courtesy of AUDI OF AMERICA, LLC

-- Clean transmission oil pump cover sealing surface on transmission housing.

Courtesy of AUDI OF AMERICA, LLC

-- Position transmission oil pump cover -A- and tighten. Refer to the appropriate service information. .

-- Install the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Refer to TRANSMISSION FLUID, DRAINING AND FILLING , fill transmission oil and check oil level TRANSMISSION FLUID LEVEL, CHECKING .