General Repair Information

• Carefulness, cleanliness and the correct tools are required for transmission repairs to be successful. The usual basic safety precautions also, naturally apply when carrying out vehicle repairs.
• Some general repair information that applies to several procedures throughout this information is summarized here. They apply to this repair information.

Guided Fault Finding, OBD and Test Instruments 

• Before starting any repairs on the transmission, determine the cause of the damage as accurately as possible. Refer to Vehicle Diagnostic Tester, Guided Fault Finding  , OBD  or Test Instruments  .

Special Tools and Equipment 

For a complete list of special tools used in the Repair Information. Refer to Audi Special Tools and Equipment Program in Service Net.

Oil, Environmental and Disposal Regulations 

• Handle ATF, axle oil and other fluids with care.
• Dispose of drained ATF properly.
• Follow the legal environmental and disposal regulations.
• Follow the information provided on oil packaging.

Transmission 

• Do not run engine or tow the vehicle when the ATF oil pan is removed or when there is no transmission fluid.
• Always clean the connection locations and the area around them before loosening.
• During installation, make sure that the alignment bushings are fitted correctly.

O-Rings, Gaskets, Seals 

• O-rings, gaskets and seals must be replaced.
• Seals are also called shaft seals.
• After removing gaskets, examine contact surface on housing/shaft for burr resulting from removal or for other signs of damage.
• Thoroughly clean housing joint surfaces before assembling.
• Replace paper gaskets, thoroughly clean sealing surfaces and completely remove old seals.
• Lightly coat the seals with ATF along outer circumference and along the sealing lip.
• Coat the O-rings with transmission fluid or Vaseline before inserting them so they are not crushed during installation.
• Do not use any other lubricants in the gear oil area. Otherwise there is a danger of malfunction of the transmission hydraulics.
• The open side of the shaft seals point toward the fluid to be sealed in.
• Press in the new shaft seal, so that the sealing lip does not run on the same point as the sealing lip of the old shaft seal (use insertion depth tolerances).
• Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

Fasteners 

• Do not overstretch the circlips.
• Replace damaged or stretched circlips.
• The circlips must fit completely inside the groove.

Bolts and Nuts 

• Loosen the bolts opposite the tightening sequence.
• Nuts and bolts which secure covers and housings should be loosened and tightened crosswise in stages if no tightening sequence is specified.
• Replace the self-locking nuts.
• Use a wire brush to clean the threads of bolts that were screwed in with locking compound. Install the bolts with Locking Fluid:AMV 185 101 A1  .
• The tightening specifications stated apply to non-oiled nuts and bolts.