Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Mounted In Transmission
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2017 Audi A3, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
Filling The Joints With Grease
| Grease - Refer to the parts information | Outer Joint | Inner Joint/Triple Roller Joint |
|---|---|---|
| Total quantity | 120 g | 140 g |
| In joint | 80 g | 70 g |
| In protective joint boot | 40 g | 70 g |
Fig 1: Exploded View Of Drive Axle With Triple Roller Joint (AAR2600I/AAR3300I) Mounted In Transmission
- Outer CV Joint
- Replace only as complete unit
- Removing. Refer to REMOVING THE OUTER CV JOINT
- Installing: Drive onto shaft with plastic mallet until the compressed circlip seats
- Checking. Refer to OUTER CV JOINT, CHECKING .
- Bolt
- 200 Nm + 180° turn
- Always replace if removed
- Loosening and tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Before installing, clean the threads in the CV joint with a tap
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Thrust Ring
- Not installed on all versions
- Installed position. Refer to the appropriate service information.
- Plate Spring
- Not installed on all versions
- Installed position. Refer to Figure
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- CV Boot
- Check for tears and scuffing
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- Drive Axle
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- CV Boot for Triple Roller Joint
- Check for tears and scuffing
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- Triple Roller Star with Rollers
The chamfer -arrow- points to drive axle splines
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Joint
- Locking Ring
- Always replace if removed